D-BOX System Configurator

Improvement and Fixes:
- New firmware addressing various issues for G2, G3 and G5 haptic systems
- New firmware for KCU-1P to optimize USB Communications
- New firmware with minor improvements for KCA

Improvements and Fixes:
- New firmware addressing remaining issues for haptic systems using G3 (with ACM G3 FLEX) and G5 actuators together
- Fixed the issue with Windows 11 where installing System Configurator as a standard user caused that user to not retain any elevated privileges, causing .NET 5 to not install properly

*HaptiSync Center v1.1.1 (or newer) required

Improvements and fixes
- New firmware releases to improve system stability (G2, G3 and G5)
- Support for the upcoming ACM G3 FLEX (firmware and configuration)

Added support for silent firmware updates from the command line, with support for multiple comm units plugged in at once. This can be done like this: .\SystemConfigApp.exe -UpdateFirmware. The return values of the program are as follows: 0 indicates an update success on all comm units, 1 indicates a success on some comm units, 2 indicates a failure on all comm units.
Added support for running the installer silently from the command line, like this: .\Setup.exe /silent /AcceptLicense: Yes

Initial support for upcoming ACM G3 FLEX
Bug Fixed: Reprogramming failure could occur while erasing the Flash on some devices
Minor improvements and corrections to the Enumeration Tool

KCU
- Changed Product name string to "D-BOX KCU"
- Added Reboot command
KCA
- Added new command to configure if and when the volume feedback wave is played. By default, no feedback wave is played.
ACM G2/G3 DSP and G5 Haptic Bridge
- Added new command KC_GETSET_VOLUME_FB_CONFIG to configure if and when the volume feedback wave is played. By default, no feedback wave is played.
G5 Haptic Bridge USB
- Changed Product name string to "D-BOX Haptic Bridge".
G5 Haptic Expander support
- The configuration section has been updated to display new diagrams when using the Haptic Expander.

Firmware package 1.8 is included in this new version

KCA
- The effect of the Spectrum setting was inverted in respect to the other products. It is now applied the same way.
ACM G2/G3
- Fixed a bug in the Runtime data management that had the potential to prevent the DSP from starting properly
- Volume and Spectrum settings can now be preserved in Flash memory
- Correction to Hold Low state that was not operating as expected with some platform configurations
- Support for new AIF parameters: Assignation and Position
- Runtime Data can now be read/cleared on a secondary ACM
- Fixed a bug that could prevent the platform from initializing properly after resyncing
G5 Haptic Bridge
- Correction to Hold Low state that was not operating as expected with some platform configurations
- Corrections to the mechanisms to save the Runtime Data into the external Flash Memory
G5 Haptic Actuator
- Correction to HOLD_LOW state: Not affected by the Mix Matrix and PlayWaves anymore
- IGBT Temperature safety limits added
- Changes to Ambient Temperature measurement to use the calibration values
- Changes to the Over and Under limits for the Ambient Temperature
- Wait for the hardware delay (for IGBT power) before proceeding with the supply voltage detection
- Wait for communications to begin with the Bridge before starting to act locally on communication errors
- Corrections to the mechanisms to save the Runtime Data into the external Flash Memory

D-BOX System Configurator - Release Notes