System faults & alarms
      Back to home
      1. Knowledge Base
      2. Haptic System General Information
      3. System faults & alarms

      Power Bridge Temperature High Fault

      Presentation of the potential causes for the above mentioned fault and prescribed corrective actions.

      Handling actuator cables and connections while the ACM, Haptic Bridge or Haptic Actuator is powered could cause injury or death due to the high voltage involved. Always turn off the system power by unplugging the ACM or Haptic Bridge power cord before handling any cables or connections.

      NOTE: Cooler Master Motion 1 gaming chair and D-BOX VIBE chair are powered by a G5 Haptic System.

       

      Potential causes

      Corrective actions

      G1/G2/G3/G5 Haptic System
      The ACM (G3) or Haptic Actuator power bridge (G5) has overheated, or the sensor is defective.
      1. Disconnect the power, wait for at least one minute, and then attempt to power it on again.
      2. Allow the system to cool down for a period of time and monitor whether the temperature returns to normal levels.
      3. If the error persists, contact D-BOX Customer Support.